Side Covers

We've redesigned the the way our side covers are attached.

The newly designed hook is rubber coated to reduce friction

on the rubber band that connects them. This will extend the life of the

rubber bands to help prevent losing your right side cover.


	*NEW* Airhead Custom Side Covers We have just finished a new pair of side covers based on the /5 Toaster side covers. They are slightly elongated and rounded at the bottom. Also, as you can see, they are rounded to the center giving them an outward bulge in the middle. This allows the side covers to fit over the electronics on /6 and /7 bikes. Fits Slash 5, 6, 7, R100 Etc Twin Shock Airheads, both SWB and LWB, through 1984. Note: Your sub frame must have the metal tabs as shown below under the /5 Toaster Side Covers. Does not fit R45 and R65. $70 / pair



	Slash 5 Toaster Side Covers Rubber Bands sold separately below. $70 / pair Hand Laid Epoxy Glass A reproduction of the original stainless steel BMW Toaster Side Covers, for color matching or custom color applications. We can also sell a single Side Cover for $35 each
	The Slash 5 Toaster Side Covers fit both SWB and LWB subframes ( /5 thru R100) that have the two metal tabs on the upright bar as shown in the photo to the left. You must have the tabs on the subframe to hold the side covers in place. The photo at right shows the /5 Toaster Side Covers on a /6 LWB bike.

	BMW /6 , /7 , R100 Side Covers (Battery Covers) Rubber Bands sold separately below. $70 / pair We can also sell a single Side Cover for $35 each
	Rubber Bands Replacement Rubber Bands for all side covers. $5 / pair

To Order Call (479) 359-2429

PLEASE READ

Our fiberglass parts are unfinished. This means you will need to sand, prime and paint the part. You will also need to drill any holes necessary to mount the part. Mounting hardware is not included, only the replacement fiberglass part. If any hardware is included with the part, it will be stated in the description.

NOTE: Occasionally there may be surface imperfections that will need to be sanded or filled and leveled. Some parts may have flashing that will need to be sanded, filled and leveled.

Air bubbles are an inherent problem with hand laid fiberglass.

Occasionally you may expose an air bubble while sanding the surface. Any air bubbles will need to be filled, sanded and leveled.

You can read more on our FIBERGLASS PART INSTRUCTIONS page.

Thank You.

HOME

Boxer Cafe / Fiberglass Specialties, 15715 Ashmore Dr., Garfield, Arkansas 72732