Cafe and Custom Fenders

	Slash 5 Café $95 We took the stock Slash 5 front fender and removed the edge and center ridges. We left it full length so you can cut and trim it for your custom application.
	We removed 8" from the front and 3" from the rear of this Slash 5 Café fender.

	Elephant Ear Fender $130 OEM Weight - 2 lb. 15 oz. Our Weight - 1 lb. 13 oz.


	Monolever Custom Fenders
	Shorty Café Fender for Monolever, with hardware $75 Hardware includes Stainless Steel Socket Head Cap Screws, Washers, Nylon Lock Nuts and Aluminum Spacers Fits 1985 through 1995 R80 and R100 Monolevers
	Spiegler Custom 2 piece Brake Line Kit for Monolever $115 Each separate right and left line connects from the caliper to the splitter under the tank. Fits 1985 through 1995 R80 and R100 Monolevers

	Monolever Rear Fender – Custom Round Side 1985 – 1995 R80 and R100, RS & RT. Does not fit R100R or GS. We developed this custom Monolever rear fender so you can give your “newer” airhead that older look. $160

	Shorty Cafe Front Fenders for Slash 6 and Slash 7
	Shorty Café Fender with side mounts $70 This fender works with the San Jose brace or the Luftmeister brace, but not with the factory pressed steel brace. We do not recommend riding without a fork brace. This fender does not take the place of a brace, it does not have enough strength.
	Shorty Café Fender without side mounts $55

The two "Shorty" fenders are the same design, one with side mounts and the other without side mounts.	The Shorty Café Fender with side mounts can be used in conjunction with the San Jose brace.	The Shorty Café Fender with side mounts can be used with the 2 piece Luftmeister fork brace, but the braces will need to be separated further apart than normal.
The Shorty Café Fender without side mounts can be used with the stock pressed steel fork brace.	The Shorty Café Fender without side mounts can be used with the San Jose brace.

To Order Call (479) 359-2429

PLEASE READ

Our fiberglass parts are unfinished. This means you will need to sand, prime and paint the part. You will also need to drill any holes necessary to mount the part. Mounting hardware is not included, only the replacement fiberglass part. If any hardware is included with the part, it will be stated in the description.

NOTE: Occasionally there may be surface imperfections that will need to be sanded or filled and leveled. Some parts may have flashing that will need to be sanded, filled and leveled.

Air bubbles are an inherent problem with hand laid fiberglass.

Occasionally you may expose an air bubble while sanding the surface. Any air bubbles will need to be filled, sanded and leveled.

You can read more on our FIBERGLASS PART INSTRUCTIONS page.

Thank You.

HOME

Boxer Cafe / Fiberglass Specialties, 15715 Ashmore Dr., Garfield, Arkansas 72732