Read Titan Fairings

Half Fairing, Dash and BMW specific Lowers

Read Titan (Churchgate)

Our molds were made from an original Read Titan (Churchgate) fairing, dash and BMW specific lowers.

This fairing was designed to use a 6” headlight mounted into the fairing.

Fairing: $240

Dash: $70

Lowers (pair) $120

Windscreen: $130 (clear only, tinted windscreens available from www.bikescreen.com)

Nose Cone: $60

Please note, we stock Gustafsson Plastics windscreens. The fairings and the windscreens are not pre-drilled.

We do not have any mounting brackets available. You will need to fabricate your own mounting system.

Fairing/Headlight Mounting Information: This fairing is typically mounted so the headlight opening is positioned higher and ahead of the stock fork mounted headlight assembly. The stock headlamp is removed from the nacelle and a separate headlight is mounted to the fairing. The nacelle is left in place attached to the forks and a wire harness “extension” is used to connect the headlight.

Dash is available in black or gray.

PLEASE READ

Our fiberglass parts are unfinished. This means you will need to sand, prime and paint the part. You will also need to drill any holes necessary to mount the part. Mounting hardware is not included, only the replacement fiberglass part. If any hardware is included with the part, it will be stated in the description.

NOTE: Occasionally there may be surface imperfections that will need to be sanded or filled and leveled. Some parts may have flashing that will need to be sanded, filled and leveled.

Air bubbles are an inherent problem with hand laid fiberglass.

Occasionally you may expose an air bubble while sanding the surface. Any air bubbles will need to be filled, sanded and leveled.

You can read more on our FIBERGLASS PART INSTRUCTIONS page.

Thank You.

To Order Call (479) 359-2429